SINIWO is a comprehensive manufacturer of access door entry keypad in China for 19 years. Base on the original metal keypads, SINIWO developed a series of access door entry keypad, mainly for industrial areas with vandal proof, waterproof, anti-corrosion features.
Access door entry keypad provides comprehensive access control for all outdoor and indoor locations. Door/system status is indicated by a high intensity LED light source and an audible sounder. Access door entry keypad is specified to survive in different service environments, ranging from exposed unsupervised public locations to general service indoor applications. Keypads in the access control system range are dimensionally and electrically interchangeable. This allows users, entering codes at both outdoor or indoor access points, to establish and maintain familiarity with the keypad features.
1. Parameter ofaccess door entry keypad
| Model No. | B886 |
| Waterproof Grade | IP65 |
| Power Supply | 12VDC-24VDC |
| Standby Current | Less than 30 mA |
| Working Method | Code input |
| Storage User | 5000 |
| Door strike Times | 01-99 seconds adjustable |
| LED Illuminated Status | Always Off/ Always On/ Delayed Off |
| Actuation Force | 250g/2.45N(Pressure point) |
| Working Temperature | -30℃~+65℃ |
| Storage Temperature | -25℃~+65℃ |
| LED Color | customized |
2. Dimension Drawing:
3. Electrical and data connections
Pin 1: GND-ground
Pin 2: V- –Power supply negative
Pin 3: V+ — Power supply positive
Pin 4: Signal-Door/call bell-Open collector gate
Pin 5: Power- Power supply for door/call bell
Pin 6&7: Exit button- Remote/exit switch- to open door form secure area
Pin 8: Common- Door sensor common
Pin 9: NO sensor- Normally open door sensor
Pin 10: NC sensor- Normally closed door sensor
Note: When making connection to the door strike, select door sensor normally open or normally closed to suit the intended application and locking mechanism.
4. Installation instructions
Fixing instructions: please read carefully before commencing installation.
A. Using the case as a template, mark the position of the four hoes on the surface.
B. Drill and plug the fixing holes to suit fixing screws(supplied).
C. Run the cable through the sealing grommet.
D. Secure the case to the surface using the fixing screws.
E. Make the electrical connections as shown in the below wiring diagram to the connector block.
Connect the casing to the earth.
F. Fix the keypad to the rear case case using the security screws(Use the nnylon sealing washers under the screw heads)
